Toro Precision Soil Sensor Instrukcja Szybki Start Pobierz pdf (Strona 4)

1. Attach the receiver next to the irrigation controller using the two

stainless steel screws provided (Fig. 2). Where appropriate, foam tape

(provided) can be used to attach the receiver.

Warning: Disconnect 24 VAC power to controller before connecting

receiver. DO NOT connect receiver to 110/220 VAC (house current).

2. Routethereceivercableintothecontrollercabinet.

Note: If your controller has a sensor bypass switch, make sure

itissettoenablethesensor.Referto

the irrigation controller’s user guide

for specifics.

3. Connect the receiver per the applicable

wiring diagram (Fig. 3a or 3b).

*Note:ForaNormallyOpensensor

application, connect the Yellow wire in

place of the Brown wire.

4. Applypowertocontroller. The receiver

will appear as shown below when power

is first applied. If the display and LED are

noton,checktheRedwireconnections.

Step 2 - Install and Connect the Receiver

Remove

Jumper

Red

Brown

White

Receiver Cable

24 VAC

Controller with Sensor Terminals

Yellow (see *Note)

Yellow (not used)

Transformer

(power to the controller)

Fig. 3a

Fig. 2

Transformer

(power to the controller)

Fig. 3b

Controller without Sensor Terminals

Brown

White

Red

Valve

Common

from Field

Receiver Cable

24 VAC

Valve Common

Rain Sensor Terminal

1 2 3 4 5 6 7 8 9 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Toro Precision Soil Sensor Instrukcja Szybki Start Strona 4

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Toro Precision Soil Sensor